Could you please try the following steps below to resolve the issue:
*Disconnect the device
*Switch the device off
*Remove the device from your phones or tablets Bluetooth settings. This can be found in General Settings>Bluetooth Settings on most devices.
*Manually log out the app (closing the app doesn't log you out)
*Close the app
*Open the app
*Type email address and password to login
*Switch device on
*Connect device
*Re-try the sync ensuring that your phone/tablet are in close proximity to each other during the entirety of the update. This will ensure the Bluetooth connection is maintained.
Its also important to make sure the WIFI connection is strong, the Shot Scope device and the phone/tablet are near to each other and that the device isn't interrupted during the process (best to keep it on the Shot Scope app until sync is complete).
If this doesn't work then contact us please at support@shotscope.com
Comments
1 comment
My firmware update was stuck. I followed the instructions to unpair the watch from Bluetooth and then I added a new device from within the app. I then re-paired the watch and now the firmware update is successful.
Please sign in to leave a comment.